Heat Pumps use energy to transfer warm or cool air from one part of your space to another. In the winter season it would heat the air from outside and transfer it inside, thus making the space warmer and during the summer season, it transfers warm air out to lower the temperature within the space. Heat pumps are generally more energy-efficient as compared to a unit from HVAC contractors near me or resistive heaters and utilize less energy consumption. Even modified products like clothes dryers and water heaters with heat pump technology are more efficient and cost-effective to operate.
Let us look at some of the features that make the new heat pumps more energy efficient:
High SEER rating
The SEER rating is the comparison between the energy consumed by the heating/ cooling units from resistive heaters contractors, HVAC contractors, or best furnace installers near me and the heating/ cooling capacity of the heat pump. After 2015, the US Department of Energy has set the minimum seasonal energy efficiency ratio (SEER rating) for heat pumps to be 14 with a heating seasonal performance factor rating of 8.2.
Variable speed motors and two-stage compressors
The new heat motors achieve high SEER ratings through adjusting speed motors concerning temperature, humidity, and other contributing factors. Thus, the new heat pumps are comfortable, clean, quiet, and most importantly energy efficient. According to the Office of Energy Efficiency and Renewable Energy, we can up to 75% of energy use with a heat pump service in Atlantic Beach motor adjusting at half its speed.
A single-stage compressor would work at the same speed and use the same amount of energy every time it is in use. However, the two-stage compressors act like variable-speed compressors, as they adjust according to needs depending on the conditions outside. This benefits us in two ways, it saves us a lot of energy consumption and because the device is not continuously running at full speed it increases the life cycle of the heat pump.
With the advancement in technology, our devices and heat pump systems are getting better and smart with time. The heat pumps have sensors and features that regulate the speed of the motor based on the surrounding conditions and needs of the owner.
Opting for Geothermal heat pumps
The temperature is constant below the surface of the earth, hence a geothermal heat pump also known as the earth-coupled, ground-source or water-source heat pump uses it as an exchange medium instead of the outside air. For more information, you can contact or search for heating contractors near me.
Like any other heating system such as an HVAC unit or furnace installation near me the energy efficiency of a Heat Pump being installed increases effectively in buildings with high levels of thermal efficiency. This can be achieved by insulation and air sealing. If you also wish to save your cost of electricity bills in Atlantic Beach, Fl called the Island Heating and Air Conditioning or call at (904)-333-6749.